Map: Natural Earth
ITAD
ITAD in Brazil: IT Asset Disposition by Reboot Monkey
ITAD in Brazil covers the end-of-life handling of a customer's IT hardware: collection and transport, data wiping or physical destruction of the storage media, and resale or buyback of equipment that can be used again. Reboot Monkey staff process the hardware in a partner's processing facility or on the customer's site.
9
of our services in Brazil
In depth
ITAD: 7 sections, open any to read more.
ITAD in Brazil: How It Works
IT asset disposition (ITAD) is the end-of-life handling of a customer's IT hardware: collection and transport, data wiping or physical destruction of the storage media, and resale or buyback of the equipment that can be used again. In Brazil the work begins when servers, network equipment and storage arrays leave production, and it is finished when every device, and every drive inside it, has a defined outcome.
Reboot Monkey delivers ITAD in Brazil as a third-party datacenter services operator. It sells rack space, IP transit, leased IP addresses, network and data-centre hardware, together with the services that deliver, install and support them, inside data centres that other companies own and run. It is not a hosting company and it does not own datacenters. For ITAD this has a practical consequence: the hardware being retired sits either in a rack inside a building the customer does not run or in the customer's own premises, and the job is organised around that location.
The processing is carried out by Reboot Monkey staff, either in a partner's processing facility or on the customer's site. Which of the two applies depends on what is being retired and on how its storage media are to be treated, so it is a point to settle before collection is booked.
ITAD is easily confused with data center decommissioning. Decommissioning is the removal and disposal of retired hardware. ITAD covers what happens to the retired equipment and its data afterwards: collection, wiping or destruction, and resale or buyback. A project that clears a room or a set of racks can therefore involve both services, with decommissioning handling the removal and ITAD handling the disposition of each device.
Before a quote is requested, the buyer needs a short list of decisions to hand: which equipment is retired, where it physically sits, whether its storage media will be wiped or physically destroyed, and whether reusable equipment is offered for resale or buyback. Resale or buyback applies only to equipment that can be used again, and it is quoted case by case. Each of these answers maps directly to a step in the job, which is why the request asks for them.
E-waste Rules in Brazil
In Brazil, electronic waste falls under the Decree No. 10,240 of 2020. Retired servers, switches, routers and storage arrays become electronic waste once they leave production, so an ITAD job in Brazil always involves material that falls under that decree. Reboot Monkey's part in the job is the physical and logistical handling of the equipment.
That handling follows defined steps. Reboot Monkey collects the retired hardware at the customer's site or data centre and transports it for processing. Reboot Monkey staff then process it, either in a partner's processing facility or on the customer's site. Equipment that can be used again can be resold or bought back, and the offer for it is prepared for the specific equipment involved.
A retirement project produces distinct streams of material, and the request is easier to scope when the customer separates them in advance:
- Equipment that can be used again: candidates for resale or buyback.
- Storage media: drives that go to data wiping, or to shredding or degaussing on the customer's site.
- Everything else: hardware with no further use, collected and transported for processing.
Personal Data on Retired Drives in Brazil
In Brazil, personal data on retired drives falls under the General Data Protection Law (LGPD), overseen by the National Data Protection Authority (ANPD). A drive that has left production still holds whatever it held in production, so every retired drive is a data-protection question as well as a logistics item.
The ITAD service offers two ways to deal with storage media. Data wiping works on the data while the device remains intact. Shredding and degaussing destroy the media physically, and they take place on the customer's site. Choosing on-site destruction therefore means the media is destroyed at the customer's location rather than in a processing facility.
Which drives carry personal data is known to the customer and not to the team that collects the hardware, so the request has to say so. A single rack can hold drives from several systems, and the work is easier to execute when drives are grouped by system and by treatment. Drives that are to be wiped and drives that are to be destroyed should be identifiable from each other before collection, because they follow different routes.
For equipment leaving a data centre as part of decommissioning, the same drive decisions apply. Decommissioning removes the hardware, and ITAD settles what happens to the data on it. The questions to answer per group of drives are:
- Did the system that used these drives hold personal data?
- Is the hardware to be resold or bought back, or is it at the end of its use?
- Is wiping the intended treatment, or is physical destruction by shredding or degaussing required?
- Does the destruction have to take place on the customer's site?
How Collection and Destruction Work
A request follows the same sequence wherever the hardware is. Each step below uses only what the ITAD service defines.
- Request: the request states where the hardware is (the customer's own site or a rack in a data centre), which equipment is retired and which storage media it contains.
- Scoping: each group of storage media is assigned to data wiping or to shredding or degaussing on the customer's site, and any reusable equipment is flagged for resale or buyback.
- Collection: a Reboot Monkey engineer is dispatched to the customer's site or data centre and collects the retired hardware there.
- Transport: the collected hardware is transported for processing.
- Processing: Reboot Monkey staff process the hardware in a partner's processing facility, or on the customer's site where the media is shredded or degaussed there.
- Resale or buyback: equipment that can be used again is quoted case by case.
Why Reboot Monkey for ITAD in Brazil
Reboot Monkey delivers ITAD alongside its other physical datacenter services: remote hands, smart hands, rack and stack, server migration, data center decommissioning and hardware monitoring. Retirement rarely stands alone in an infrastructure project, and these services can be combined as the job requires:
- ITAD with data center decommissioning: retired hardware is removed from the racks, then collected, wiped or destroyed, and resold or bought back where it can be used again.
- ITAD with server migration: equipment moves between racks, rooms or facilities, and the hardware left behind is retired.
- ITAD with rack and stack: new hardware is installed, mounted and cabled, and the hardware it replaces is retired.
- ITAD on its own: hardware that is already out of service is collected at the customer's site or data centre and transported for processing.
How Reboot Monkey Handles IT Asset Disposition
These terms apply to IT asset disposition in Brazil.
- Where the work is done: the processing is done by Reboot Monkey's own staff, in a partner's processing facility or on the customer's site, agreed case by case.
- Resale and buyback: reusable hardware can be resold through Reboot Monkey's procurement desk or bought back, quoted case by case.
Data sanitization and certificates
The data centres we work in hold their own certifications, such as ISO/IEC 27001 and ISO 9001. Ask us for the certificate of your site. Our ITAD partner's sites include facilities certified to ISO 9001, ISO 14001, ISO/IEC 27001 and ISO 45001. Ask us for the certificate of the site that handles your job.
- NIST SP 800-88 data sanitization
- Certificate of Destruction issued per storage device processed
Frequently Asked Questions
What does IT asset disposition cover in Brazil?
IT asset disposition covers the end-of-life handling of a customer's IT hardware: collection and transport, data wiping or physical destruction of the storage media, and resale or buyback of equipment that can be used again. In Brazil, electronic waste falls under the Decree No. 10,240 of 2020, and personal data on retired drives falls under the LGPD, overseen by the ANPD.
Where does Reboot Monkey process retired hardware in Brazil?
The processing is done by Reboot Monkey's own staff, in a partner's processing facility or on the customer's site, agreed case by case. The customer and Reboot Monkey settle which of the two applies before the job is scheduled, and the collection and transport of the hardware are arranged with the customer.
Can retired hardware be resold or bought back in Brazil?
Yes. Reusable hardware can be resold through Reboot Monkey's procurement desk or bought back, quoted case by case. Send the list of the hardware, with models and quantities, through the contact form, and Reboot Monkey replies with what can be resold or bought back.
How do I get a quote for IT asset disposition in Brazil?
Prices are quoted on request and depend on the customer and the size of the job. Send the site, the list of the hardware and whether storage media must be destroyed on site through the contact form, and Reboot Monkey replies with a quote for the job.
Plan the retirement of your IT hardware in Brazil
Send the location of the hardware, the equipment list and the intended treatment of the storage media, and Reboot Monkey will prepare a quote for collection, destruction and resale or buyback.