Skip to content
Map of Austria: data centres as dots, the cities with a Reboot Monkey page highlighted: Vienna

Map: Natural Earth

Data Center Migration

Data Center Migration in Austria

Data center migration in Austria is the physical move of servers and network equipment between racks, rooms or facilities, including cabling, cross connects and the removal of retired hardware. Reboot Monkey can run the whole physical move or work alongside the customer's own team, inside data centres that other companies own and run.

  • 7

    of our services in Austria

Choose your city

  • Vienna's old town from the south tower of St. Stephen's: red roofs and a green copper dome above the cathedral's patterned tile roof

    Photo: Dietmar Rabich / Wikimedia Commons / “Wien, Stephansdom, Blick vom Südturm -- 2018 -- 3268” · CC BY-SA 4.0 · source

    Vienna

    • Data Center Migration
    • Colocation
    • Data Center Decommissioning
    • Rack and Stack
    • Remote Hands
    • Server Migration
    • Smart Hands
    Data Center Migration Vienna

Services in Data Center Migration

In depth

Data Center Migration: 8 sections, open any to read more.

Data Center Migration in Austria: How It Works

A data center migration in Austria is a physical project. Servers, network equipment and cabling leave one rack, room or facility and are installed, cabled and tested in another. Reboot Monkey is a third-party datacenter services operator: it delivers this work inside data centres that other companies own and run, and it is not a hosting company or a datacenter owner. The facility operator owns and runs the building, including its power, cooling and access policy, and Reboot Monkey engineers work under the operator's site rules.

Two service definitions cover most moves. Server migration is moving equipment between racks, rooms or facilities, so a shift within one building and a move between buildings are the same service; only the place where the equipment is cabled and connected again changes. Datacenter exit and relocation is the physical move of the customer's equipment to its new location together with the removal and disposal of the hardware that is retired. A project uses one or both, depending on whether hardware is being retired as part of the move.

A request is handled in four steps.

  • Request. The customer describes the current location, the target location and the equipment that has to move. Hardware that is to be retired rather than moved is named in the same request, so removal and disposal can be scoped together with the move.
  • Scope and roles. Reboot Monkey can run the whole physical move or work alongside the customer's own team. Who disconnects, reconnects and tests the equipment is agreed per project.
  • Quote. Quotes are prepared on request and depend on the customer and the size of the job.
  • Engineers on site. Reboot Monkey engineers are dispatched to the customer's facility, and a second, briefed Reboot Monkey engineer is named as backup for every customer site.

Datacenter Landscape in Austria

Data centres in Austria, ordered by the number of networks present:

  • Digital Realty VIE1/2 - Vienna, Louis-Haefliger-Gasse 10, 1210 Vienna: 192 networks; carriers Arelion, Aristo Networks, Core-Backbone, EXA Infrastructure, Eranium Fabric and others
  • NTT Vienna1 Data Center (VIE1) (NTT DATA's Global Data Centers division), Computerstraße 4, 1100 Vienna: 46 networks; carriers Core-Backbone, EXA Infrastructure, Inter.link, euNetworks and next layer
  • Vienna University Computer Center (Wien) (University of Vienna), Universitaetsstrasse 7, 1010 Vienna: 27 networks; carriers Core-Backbone, euNetworks and next layer
  • DATASIX Vienna (VIE1) (DATASIX Rechenzentrumsbetriebs GmbH), Hofmuehlgasse 3-5, 1060 Vienna: 20 networks; carriers Arelion and euNetworks
  • Stadtwerke Klagenfurt (Stadtwerke Klagenfurt AG), Gabelsbergerstraße 50a, 9020 Klagenfurt am Wörthersee: 19 networks; carriers next layer
  • Kelag Klagenfurt (oja.at GmbH), Arnulfplatz 2, 9020 Klagenfurt: 18 networks
  • Techno-Z (Techno-Z Verbund GmbH), Schillerstraße 30, 5020 Salzburg: 18 networks; carriers Core-Backbone, RETN and next layer
  • Nessus NDC1, Fernkorngasse 10, 1100 Vienna: 13 networks; carriers euNetworks and next layer
  • Nessus NDC2, Karmarschgasse 23-25, 1100 Vienna: 13 networks; carriers euNetworks and next layer
  • Datencenter 3 - Innsbruck (HALLAG Kommunal GmbH), Eduard-Bodem-Gasse 2, 6020 Innsbruck: 10 networks

Data Center Migration by City

City pages for data center migration in Austria:

  • Vienna: https://www.rebootmonkey.com/en/austria/vienna/data-center-migration/

Data Center Migration in Austria: What We Deliver

The physical work of a migration is delivered through the service lines below. Each one is used only where the project needs it.

Not every project needs every line. A move of racked servers into new racks may need server migration, structured cabling and an inventory and nothing more. An exit from a site adds decommissioning and, where retired hardware is sold on, ITAD with buyback. A move that changes connectivity adds cross connects and carrier circuits. Because design work ends with documentation of the design and a controlled handover, the customer's own team can take over the new layout from that documentation.

The inventory is the record the finished work is checked against. Each item appears by serial number, asset tag and rack position, so the customer can compare what was moved with its own asset list and see where each item now stands.

  • Rack and stack: installing, mounting and cabling new hardware, used when the move brings in new servers or network equipment alongside the existing estate.
  • Structured cabling: installing, labelling and patching the cabling between the customer's racks and network equipment.
  • Cross-connects and carrier circuits: Reboot Monkey orders them from the facility operator and the carriers present in the facility, and its engineers install and patch the cabling in the customer's rack.
  • Dark fibre and wavelengths: dark fibre between data centres and wavelength circuits, ordered from the carriers and quoted on request.
  • Rack and network design: the rack layout and the network topology of a new or expanding deployment, ending with documentation of the design and a controlled handover.
  • Asset inventory: recording the customer's equipment in the data center by serial number, asset tag and rack position, against the customer's asset list.
  • Data center decommissioning: removing and disposing of retired hardware.
  • ITAD with buyback: IT asset disposition with the buyback of the retired hardware, quoted case by case.
  • Hardware supply and spares: supply of data-centre hardware, servers, network equipment and spare parts, with spares kept in the customer's rack on request.

Why Reboot Monkey for Data Center Migration in Austria

A migration finishes when equipment is running in its new location, but that equipment still needs hands, monitoring and network. Reboot Monkey sells rack space, IP transit, leased IP addresses, network, data-centre hardware and the services that deliver, install and support them, so the work that follows the move can stay with the same supplier.

The choice between the support lines follows the task. A reboot, a cable check, a component swap or a visual check that the customer can specify belongs to remote hands, which means physical tasks carried out on the customer's instruction. A fault that needs diagnostic judgement, or a change that needs configuration knowledge, belongs to smart hands. Equipment that has to be watched continuously is covered by hardware monitoring, which is monitoring of the customer's servers and network equipment by the Reboot Monkey NOC.

Commercial terms differ by line, and each is stated here as the facts give it:

  • Remote hands retainers and hour blocks: remote hands agreed as a retainer or as a block of hours for recurring work, with terms agreed per customer and quoted on request.
  • IP transit: offered as Economy, Premium and DDoS Premium plans, each quoted per data center for the capacity the customer needs.
  • IPv4 leasing: leasing IPv4 addresses, alone or together with IP transit and rack space.
  • ITAD with buyback: quoted case by case.

How Reboot Monkey Works

These terms apply in every facility in Austria where Reboot Monkey engineers work.

  • Response: 1-hour, around-the-clock incident response SLA, and a 15 minute premium response available where technicians are stationed on-site, as a paid add-on. The incident response SLA covers incidents and unplanned requests; on-site, dispatch and resolution times, priority tiers, and planned or scheduled work are agreed per site in the service agreement.
  • Monitoring: 24/7 NOC monitoring across all facilities, covering IPMI, iDRAC, SNMP, temperature, power, network signals.
  • Hardware: vendor-neutral technicians for Dell, HP, Cisco, Juniper and Arista equipment.
  • Independence: independent from facility operators (not Equinix SmartHands, not NTT staff).
  • One agreement: single provider across cities, so a customer in several cities needs only one agreement.
  • Service levels and terms: https://www.rebootmonkey.com/en/solutions/sla
  • Published case study: a major ICT provider engaged Reboot Monkey for three full infrastructure rollouts in Lahore, Karachi and Islamabad, with the hardware installed the same day at every site. Read the case study at https://www.rebootmonkey.com/en/resources/case-study/how-we-completed-3-full-deployments-across-pakistan

Data Center Migration

The data centres we work in hold their own certifications, such as ISO/IEC 27001 and ISO 9001. Ask us for the certificate of your site.

Data Center Migration in Other Countries

As of 2026, Reboot Monkey's field engineers work in 190 countries and more than 400 locations. A migration can start in Austria and end elsewhere, or it can touch several sites at once.

For a move that involves Australia, see Data Center Migration in Australia.

Where a migration spans several of the customer's sites, multi-site rollouts apply: one installation programme carried out at several of the customer's sites by Reboot Monkey engineers.

In a move with two ends, each item of equipment has one of three outcomes. It moves with the customer, which is server migration. It is replaced by new hardware, which is hardware supply together with rack and stack. Or it is retired, which is decommissioning and, where the hardware is sold on, ITAD with buyback. Naming the outcome for each item in the first request keeps the two ends of the project consistent.

The inventory method is the same at the source and at the target. Equipment is recorded by serial number, asset tag and rack position against the customer's asset list at each end, so the customer can follow every item from the old location to the new one.

Each end also needs its own connectivity. The cross connects and carrier circuits at the target are ordered from the operator of that facility and the carriers present there, and Reboot Monkey engineers install and patch the cabling in the customer's rack. Where equipment is to be replaced rather than shipped, hardware supply and spares provide the servers, network equipment and spare parts for the target location.

Frequently Asked Questions

What does data center migration cover in Austria?

Data center migration in Austria covers the physical move of a customer's servers and network equipment between racks, rooms or facilities, together with the cabling, cross connects and carrier circuits at the new location. When hardware is retired, removal and disposal can be added to the scope. Who disconnects, reconnects and tests the equipment is agreed per project, and quotes are prepared on request.

Do you work in every datacenter in Austria?

Reboot Monkey engineers work in any facility in Austria where the customer has equipment and access, under the operator's own access and safety rules. The customer adds the engineers to the facility's access list before the first visit.

How fast can Reboot Monkey respond in Austria?

Incidents and unplanned requests are handled under a 1-hour, around-the-clock incident response SLA. There is also a 15 minute premium response available where technicians are stationed on-site, as a paid add-on. On-site, dispatch and resolution times, priority tiers, and planned or scheduled work are agreed per site in the service agreement.

How is Reboot Monkey different from the facility operator's own staff?

Facility operators' own technicians work for the building. Reboot Monkey engineers work for the customer: they are independent from facility operators (not Equinix SmartHands, not NTT staff), follow the customer's instructions, and the same team can cover several buildings in the country under one agreement.

How do I get started with data center migration in Austria?

Send the site, the equipment and the task through the contact form. Reboot Monkey replies with a quote and an engineer plan for that facility. Once agreed, the customer adds the engineers to the facility's access list and the data center migration work is scheduled under the operator's rules.

Plan your data center migration in Austria

Describe the current location, the target location and the equipment to move. Quotes are prepared on request and depend on the customer and the size of the job.

Published:

Get a quote